Q00460003-01: SRB
When Source Route Bridge End Station Support is configured on the router, a fault may result
after aging occurs.
Q00458668-02: ATM
In a large ATM configuration with OAM configured, a watchdog may occur when there is a loss of
connectivity from the telco switch.
Q00461358-01: PPP2430
When a Xircom PCMCIA modem is used as the console port the modem will answer but
occasionally will not send the login prompt. This will result in a router fault within a few minutes.
Q00462601: BCC_FT1
The BCC ‘show ft1e1 port’ command results in an error message.
Q00464249-01: BCC_Circuitless IP
When a circuitless IP interface is configured using BCC, a different circuit name is given than
when configured through Site Manager.
Q00464803-01: WCP
Unnecessary messages fill the log when traffic is sent across slots when PPP Multilink is
configured across two slots along with WCP using hardware compression.
Q00470890-01: RIP
When RIP is configured on an ATM PVC, the router will only send 2-3 update packets per second.
As a result, it can take a significant amount of time to update the entire routing table on a large
network.
Q00472857: BCC_GRE
No IPX static host is created when the remote-endpoint of the logical-ipx-address is set to 1 in an
GRE/IPX configuration.
Q00479405: IP Traffic Filters
Changing predefined IP criteria on outbound filters may cause a fault on the router.
Q00480417: BCC_Circuitless IP
When Circuitless IP is configured using BCC on a BLN router, a BCN slot mask will be shown
when report generator is used on the configuration file.
Q00484079-02: PP2430
Repeated dialing into a PP2430 to open and close a TI session will eventually cause the router to
fault.
Q00485407: PP5430
The PP5430 router may hang after a named boot is performed.
Q00486512: BCC
When circuit-name is configured using more than 256 characters using BCC, the router faults.
Q00490342: ARP
Comentarios a estos manuales