Avaya SPEX Net Modules in ASN Platforms Manual de usuario descargar pdf (Pagina 40)

Installing SPEX Net Modules in ASN Platforms

2-6 115368-A Rev. A

Connecting Nodes with Dual SPEX-HS Cables

To connect nodes with dual SPEX-HS cables, complete the steps in the previous

section, and then

1. Use a Phillips screwdriver to remove the cover labeled RESERVED FOR

FUTURE on the SPEX-HS Port C of each ASN in the stack (Figur

e 2-4).

Figure 2-4. Cover Labeled RESERVED FOR FUTURE

Insert the connector at one end of the second SPEX-HS cable (Order No.

7166) into the SPEX-HS Port C on the ASN at the bottom of the stack.

Tighten the thumbscrews.

3. Insert the next connector on the second SPEX-HS cable into the

SPEX-HS Port C on the next ASN in the stack. Tighten the thumbscrews.

4. Repeat Step 2 for the remaining nodes in the stack.

Figure

2-5 shows four nodes connected with dual SPEX-HS cables.

Caution: To enable dual bus cable support for a SPEX-HS net module, your

router must be running Bay Networks Router Software and Boot PROM

Version 10.0 or later (or BNX Software and Boot PROM Version 6.00 or later),

and diagnostic PROM (asndiag.exe) Version 2.16 or later.

If your router is not running these minimum versions, it will not recognize the

second port.

To upgrade your diagnostic PROM, use the Technician Interface

prom

command. (Refer to Using Technician Interface Software if you use router

software or Troubleshooting and Testing if you use BayStream software.)

SPEX-HS

34007

RESERVED FOR FUTURE

ASN0026B

1 2 ... 35 36 37 38 39 40 41 42 43 44

Sin comentarios

Avaya SPEX Net Modules in ASN Platforms Manual de usuario Pagina 40