Avaya SPEX Net Modules in ASN Platforms Manual de usuario descargar pdf (Pagina 33)

Installing a Net Module

115368-A Rev. A 1-11

Replacing the Component Tray

Before you replace the component tray, remove the alligator clip of the antistatic

strap from the chassis. Then remove the antistatic wrist strap from your wrist.

To replace the component tray:

1. Gently slide the tray into the chassis.

2. Use a Phillips screwdriver to tighten the two captive screws that fasten

the tray to the chassis (refer to Figur

e 1-1).

3. Reattach the cables to the proper connectors on the back panel.

Refer to Chapter 2 for more information about attaching cables to SPEX and

SPEX-HS net modules. Chapter 3 describes how to interpret the LEDs on the net

modules.

Note: If you just installed a SPEX net module, and you are not stacking

nodes, you must insert a SPEX terminator plug (Order No. 7140) in both the

IN and OUT ports of the net module. Do not use the SPEX cable to connect

the IN port to the OUT port. If you do not have terminator plugs, remove the

SPEX net module.

If the ASN contains a SPEX-HS net module, and you are not stacking nodes,

you must attach one of the connectors on the SPEX-HS cable (Order No.

7166) to Port A on the net module. If you do not have a SPEX-HS cable,

remove the SPEX-HS net module.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Sin comentarios

Avaya SPEX Net Modules in ASN Platforms Manual de usuario Pagina 33