Avaya How to Use the Wall-Mounting Brackets Kit Manual de usuario descargar pdf (Pagina 5)

Installing the module on a wall

Required tools and material:

• Phillips screwdriver for attaching brackets to the module

• Four screws appropriate to the composition of the wall where

you will install the module

• Screwdriver appropriate to your wall-mounting hardware for

attaching the module to the wall

• (Recommended) sheet of 1/2-inch plywood attached to the

wall where you will install the module

• Expanding wall anchors if you are installing the module on a

hollow wall

• (Optional) drill for making pilot holes in the wall

• Plastic cable clamps to route and support the port cables after

you install the switch

Be aware of the following considerations when you plan the wall

installation:

• To install two modules, remember to consider their combined

weight.

• Attached cables increase the weight of the installation, and

the accumulated weight of these cables increases with the

height of the mounting location.

• Place the module at a height that allows you to see the LEDs.

• Remove any installed rack-mount brackets or rubber

footpads from the module.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Avaya How to Use the Wall-Mounting Brackets Kit Manual de usuario Pagina 5