Avaya Connecting ASN Routers to a Network Manual de usuario descargar pdf (Pagina 71)

Configuring Network Booting

303549-A Rev 00

3-21

BOOTP Client Interface Parameters

Parameter: IP Address

Default: None

Options: Any valid IP address

Function: Specifies the IP address of the booting router that is using EZ-Install. This

parameter applies only to a Frame Relay group access PVC connection.

Instructions: Enter the IP address (in dotted decimal notation) of the booting router’s

interface.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.3

Parameter: DLCI Number

Default: None

Range: 16 to 1007

Function: Specifies the identification number of the upstream router’s PVC to the

booting router. The Frame Relay network uses the DLCI number to direct

data flow from the booting router to the upstream router.

Instructions: Enter the number in decimal format. Use the DLCI number assigned by

your Frame Relay service provider.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2

What to Do Next

If you have not already done so, you must complete the steps in Chapter 2 to

configure a UNIX workstation for network booting before you can use the

network to boot an ASN.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers to a Network Manual de usuario Pagina 71