
Configuring the APPP features Chapter 5 23
Advanced Paging Productivity Pack Configuration
• When a user presses the call button on the CAB, feature F970 is initiated, and when a user
presses the Cancel button, feature F970 is released.
Procedure steps
Step Action
1 From the Element Manager navigation panel, select
Configuration > Applications > Voice Messaging/Contact Center.
2 Click Launch CallPilot Manager.
3 From CallPilot Manager, configure the required Park and Page nodes in a
custom call routing (CCR) tree.
For more information about Park and Page nodes, see the CallPilot Manager
Set Up and Operation Guide (NN40090-300).
4 Connect the CAB to an available TDM port on your BCM system.
The CAB is automatically assigned a DN.
The CAB takes approximately 2 minutes to boot. Do not use the CAB during the
boot process. To find the CAB DN check the port through Element Manager or
plug in a TDM set and press F*0.
5 In Element Manager, change the DN of the CAB, if required.
The CAB appears in the DN list as a 7208 telephone. If there are other 7208
telephones on the system, then you can determine the CAB DN by unplugging
the CAB, plugging in a telephone, and pressing F*0 on the intercom to see the
CAB DN.
6 In Element Manager (Configuration > Telephony > Sets > All DNs >
Capabilities and Preferences tab), set the name of the CAB. The CAB name
must have the format nnnnnXY.
For more information about the variable definitions for the CAB name format,
see the table CAB name format (page 23).
For more information about configuring a CAB (or TDM device), see the Device
Configuration Guide for your BCM system.
End
Variable definitions
Table 4 CAB name format
Variable Value Description
nnnnn up to five
characters
A descriptive name for the CAB.
Comentarios a estos manuales