Avaya Configuring LNM Services Manual de usuario descargar pdf (Pagina 45)

303534-A Rev 00

4-1

Chapter 4

Editing LNM Servers Parameters

This chapter describes how you use Site Manager software to

• Access LNM Servers parameters

• Edit LNM Servers global parameters

• Edit LNM Servers interface parameters

• Delete LNM Servers from a circuit

• Delete all LNM Servers from the router

After you successfully enable a set of LNM Servers on the router, you can use Site

Manager to edit parameters associated with the servers. Note that you can add

only one set of LNM Servers per physical circuit.

This chapter assumes that you have already added one or more source routing

bridges and LNM default interfaces to a router configuration file you want to edit.

(Refer to Configuring and Managing Routers with Site Manager if you need to

add LNM Servers to the configuration file.)

When you configure the LNM Servers on a token ring attachment circuit, you

supply information required by lower-layer protocols (MAC, LLC, and source

routing). These protocols together support local session termination, connection,

and source routing services for the LNM Servers on that physical circuit.

For each LNM parameter, this chapter provides information about default settings,

valid parameter options, the parameter function, instructions for setting the

parameter, and the Management Information Base (MIB) object ID.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Sin comentarios

Avaya Configuring LNM Services Manual de usuario Pagina 45