Avaya Configuring Interface and Router Redundancy Manual de usuario descargar pdf (Pagina 35)

308626-14.00 Rev 00

4-1

Chapter 4

Configuring Interface Redundancy

This chapter describes how to configure interface redundancy. It assumes you

have read Configuring and Managing Routers with Site Manager and Chapters 1

and 3 of this guide, and that you have

1. Opened a configuration file in local or remote mode

2. Specified router hardware if this is a local mode configuration file

3. Selected the link- or net-module connector on which you are enabling

interface redundancy

To enable interface redundancy, you must select at least two interfaces as

members of an interface redundancy group. One of the interfaces is the designated

primary interface; under normal circumstances it is the active interface that

provides normal routing/bridging services. The other is the redundant interface; it

takes over if the active interface fails.

Enabling Interface Redundancy

To configure an interface redundancy group:

In the Configuration Manager window, select an available LAN interface.

The Add Circuit window opens (Figure 4-1)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 89 90

Sin comentarios

Avaya Configuring Interface and Router Redundancy Manual de usuario Pagina 35