
BayRS, BCC, and Site Manager Software Version 14.20 Fixed Anomalies
10
308681-14.20 Rev 00
BayRS and BCC Version 14.20 Fixed Anomalies
Nortel Networks has fixed the following anomalies in BayRS and BCC Version
14.20.
CR-#30952-1 DLSw
The DLS slot memory statistics indicate memory being used by this DLS slot that
was not actually used. This issue not only incorrectly reflects the statistics but can
also inhibit new connection establishment, as the erroneous statistic is used to
determine whether DLS may acquire more memory from the system heap during
connection establishment.
CR-#72142-1 OSI
When a router boots with an OSI configuration it sends out an IIH hello as soon as
its OSI interfaces become active. If, however, a failed line recovers, no IIH hello is
sent over the line, so no adjacency is formed.
CR-#74514-1 PCAP
PCAP only captures packets in compressed format when WCP is enabled on the
router, causing the packets to be unreadable using PCAP/TAP. You must also use
Walts 4.01 for this fix.
CR-#74986-1 Boot
If a Mircocom Diskporte Fast Modem with its power switched off is plugged into
the console port of a BN or AN router, the router will not complete its boot cycle.
Note that FRE diagnostics version 5.16, shipped with BayRS 14.20, is required to
implement this fix.
CR-#78806-1 DLSw
The Statistics Manager's Screen Builder tool has incorrect or missing statistic
values on DLS connections in table mode.
CR-#84897-2 OSPF
When you add a summary range with the same link state ID to an area border
router (ABR), all the other area border routers fail to remove the specific routes
and summary route. This occurs even though the originating ABR is only
propagating the summary range.
Comentarios a estos manuales