
Chapter 2 Configuring Companion handsets 49
Business Communications Manager Companion Configuration Guide
Companion DN record parameters
Companion DNs are programmed in the same way as other Business Communications Manager
telephones. However, some programming settings do not affect the operation of the portable.
The following table shows the recommended settings for using Companion on the Business
Communications Manager. For detailed telehone configuration information refer to the
Programming Operations Guide.
Table 12 Companion telephone programming
Programming
level
Programming
option
Setting Notes
System DNs...,
DN XXX,
Line access
Answer DNs <set DN> This is the number of the stationary telephone
that is twinned with the handset. When the
stationary telephone gets a call, the Companion
mirrors the call.
System DNs...,
DN XXX,
Capabilities
Forward
no answer
Fwd to:
<DN>
Fwd Delay:
<no. of
rings>
This stops the Companion portable from ringing
when the call is forwarded to its new
destination. The portable user can still answer
the call, but it does not ring.
The settings for Forward no answer are found
under System DNs/Active Companion DNs/
DN##/Capabilities in the Unified Manager.
Forward on busy Y
Do not disturb
on busy
N
Handsfree N
Handsfree
answerback
None
Pickup group <group
number>
A portable can be part of a pickup group and
answers calls ringing at telephones in the same
group when the user enters FEATURE 76.
Paging Y
Page zone 1
Direct dial Set 1 A portable cannot be a Direct dial telephone. It
can use the Direct dial digit.
Hotline None
Priority call Y Requires special configuration of hardware and
programming
System DNs.../DN
XXX/Restrictions/
Set Restrictions
Set lock Y Does not apply to portables.
Allow last number Y Does not apply to portables.
Allow saved number Y Does not apply to portables.
Allow link Y or N This can be set to N for portables.
Comentarios a estos manuales