Avaya COMPANION Guía de configuración Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Chapter 1 Installing the Companion system 27
Business Communications Manager Companion Configuration Guide
Attaching a Companion base station
Install base stations on a wall or on a ceiling. When installing base stations on a wall, install them
with their covers at the bottom, as shown in the figure below. Allow for clearances around the base
station as indicated in the following table.
Installing the base station:
1 Fasten the bracket into position using two #8 38-mm (1-1/2 in.) screws.
2 Route the cable from the BCM1000 through the top or bottom opening.
3 Wind any excess cable around the posts, then fasten the cable under the strain relief.
4 Connect the wires to the BIX connector on the bracket termination board as shown in the
following figure.
Figure 9 Bracket termination board
Table 6 Minimum distance between office areas and base stations
Number of base stations in the cell Minimum distance between office areas and base stations
1 1 m (40 in.)
2 1.4 m (56 in.)
3 1.8 m (72 in.)
4 2 m (80 in.)
Table 7 Clearance for the base stations
Clearance conditions Canada USA
Clearance from all other objects 9 cm 3.5 in.
Vertical clearance from base station center to base station center
27 cm 54 in.
Horizontal clearance from base station center to base station center
41 cm 54 in.
-PWR(1)
TCM
+PWR(1)
+PWR(2)
-PWR(2)
TCM
RJ11 jack
TCM
RJ11 jack
TCM
-PWR(1)
-PWR(2)
+PWR(1)
+PWR(2)
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 55 56

Comentarios a estos manuales

Sin comentarios