Avaya Token Ring Link Modules Manual de usuario descargar pdf (Pagina 27)

114947-A Rev. A 2-1

Chapter 2

Installing the Link Module

Complete the steps in this chapter to install the Token Ring link module in your

BLN, BLN-2, or BCN platform.

Inserting the Link Module

Install the link module in the BLN, BLN-2, or BCN platform as follows:

1. Attach an antistatic wrist strap.

BN platforms and link modules ship with an antistatic wrist strap. You must

wear one of these straps whenever you access components in a platform.

The antistatic wrist strap directs the discharge of static electricity from your

body to the chassis, thereby avoiding discharge and possible damage to

sensitive electronic components.

2. Slide the module into the appropriate slot, using the slot card guides.

Refer to Figure 1-1 (BLN), 1-2 (BLN-2), or 1-3 (BCN) for slot locations.

3. Insert the module until its connector panel touches the back panel of the

BN platform.

4. Secure the captive screw on each end of the module (Figure 2-1).

Figure

2-1 shows the captive screws on a Dual Token Ring link module; these

screws are the same on all link modules.

Caution: Electrostatic discharge can damage hardware. Always use the

antistatic wrist strap when handling any component in the BN platform.

1 2 ... 22 23 24 25 26 27 28 29 30

Sin comentarios

Avaya Token Ring Link Modules Manual de usuario Pagina 27