Avaya SRM Link Modules in BN Platforms Manual de usuario descargar pdf (Pagina 24)

Installing SRM Link Modules in BN Platforms

1-4

115622-A Rev. A

The BN hot-swap feature allows you to remove or replace an SRM-L with the

chassis power on or off.

The procedure for removing an SRM-L is the same for the BLN, BLN-2, and

BCN platforms:

Disconnect any exterior cables from the link module.

Attach an antistatic wrist strap.

BN platforms and link modules ship with an antistatic wrist strap. You must

wear one of these straps when accessing components on BN platforms. The

antistatic wrist strap directs the discharge of static electricity from your body

to the chassis, thereby avoiding discharge and possible damage to sensitive

electronic components.

Loosen the captive screw on each end of the module.

Grasp the sides of the module and pull it out of the slot.

Place the module in an antistatic protective bag.

Danger:

A potential energy hazard exists during hot-swap service of link

modules. Do

not

remove more than two adjacent modules without powering

off the BN platform.

Caution:

Electrostatic discharge can damage hardware. Always use the

antistatic wrist strap when handling any component on your BN platform.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Avaya SRM Link Modules in BN Platforms Manual de usuario Pagina 24