
Tech Tip
Contivity Secure IP Services Gateway
Configuring Branch Office Tunnel between a Contivity and a BayRS
router
6. Reenter Image Builder through Tools | Image Builder and open up the original image
file in the builder.dir directory, the same way as in step 2. Check the Details button on
the left-hand side of the screen, and highlight capi.exe. Note the size of this file is much
larger than the dummy file (In this case, about 82K). Click Add >> to install the real
capi.exe file into the image. Once done, Save and Exit image builder and retrieve the
image file from the builder.dir directory. This image is now ready to load onto the router.
Copyright © 2005 Nortel Networks Limited - All Rights Reserved. Nortel, Nortel Networks, the Nortel logo, Globemark, and
Contivity are trademarks of Nortel Networks Limited.
The information in this document is subject to change without notice. The statements, configurations, technical data, and
recommendations in this document are believed to be accurate and reliable, but are presented without express or implied
warranty. Users must take full responsibility for their applications of any products specified in this document. The
information in this document is proprietary to Nortel Networks Limited.
To access more technical documentation, search our knowledge base, or open a service request online, please visit
Nortel Networks Technical Support on the web at:
http://www.nortel.com/support
If after following this guide you are still having problems, please ensure you have carried out the steps exactly as in this
document. If problems still persist, please contact Nortel Networks Technical Support (contact information is available
online at:
http://www.nortel.com/cgi-bin/comments/comments.cgi?key=techsupport_cu).
We welcome you comments and suggestions on the quality and usefulness of this document. If you would like to leave a
feedback please send your comments to:
Author: Christopher Costa
TT040916 1.00 September 2004 Page: 29 of 29
Comentarios a estos manuales