
Configuring APPN Services
3-18
Parameter: Port Enable/Disable
Default: Enable
Options: Enable | Disable
Function: Enables or disables APPN routing on this port.
Enable — Initializes the selected APPN port. You can also use the Enable
setting to initialize an existing APPN port that you disabled earlier.
Disable — Forces the APPN port into the “down” (inoperative) state.
Instructions: Select Disable to disable APPN routing over this port.
Select Enable to enable or re-enable APPN routing over this port.
MIB Object ID: 1.3.6.1.4.1.18.3.5.14.1.3.1.2
Parameter: Port Address
Default: None
Options: None
Function: Specifies the interface address for this port.
Instructions: This is the MAC address, SDLC address, or DLCI and SAP address that
you specified when you added the original circuit to the interface. A MAC
address starts with the 0x prefix and ends with the SAP value.
MIB Object ID: 1.3.6.1.4.1.18.3.5.14.1.3.1.38
Comentarios a estos manuales