Avaya WLAN IP Telephony Configuration BCM Rls 6.0 Manual de usuario descargar pdf (Pagina 10)

WLAN IP Telephony Configuration

10 NN40011-038 Issue 1.2 BCM Rls 6.0

3. Screw the other end of the two mounting plates (oblong screw holes) to

the rack.

4. Repeat steps 1-3 for each additional WLAN IP Telephony Manager

2245. The mounting plate is designed to provide the correct minimum

spacing between units. When mounting multiple units, stack the units in

the rack as closely as possible.

Wall Mounting

The WLAN IP Telephony Manager 2245 can be mounted either vertically or

horizontally.

To wall-mount the WLAN IP Telephony Manager 2245:

1. Use a 1/8-inch drill bit to drill four holes. The holes should be on 1.84

by 12.1 inch centers.

2. Insert the #8 x 3/4-inch screws in the holes and tighten, leaving a 1/8 to

1/4-inch gap from the wall.

3. Slide the WLAN IP Telephony Manager 2245 over the screws until the

WLAN IP Telephony Manager 2245 drops into place in the keyhole

openings of the flange.

4. Tighten screws fully.

Rack-Mounting

The rack-mount kit is designed for mounting the WLAN IP Telephony

Manager 2245 in a standard 19-inch rack. The following equipment is required

and supplied:

1. Mounting plates: two plates are required for the WLAN IP Telephony

Manager 2245 to be mounted.

2. Screws: four rack-mount screws are required for each WLAN IP

Telephony Manager 2245 to be mounted.

To Rack-Mount the WLAN IP Telephony Manager 2245

1. Remove the corner screws from the WLAN IP Telephony Manager

2245.

2. Screw the U-shaped end (round screw holes) of the two mounting

plates to the WLAN IP Telephony Manager 2245.

3. Screw the other end of the two mounting plates (oblong screw holes) to

the rack.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

Sin comentarios

Avaya WLAN IP Telephony Configuration BCM Rls 6.0 Manual de usuario Pagina 10