
Installing a System Processor Card in the Passport 5430 Multiservice Access Switch
3-4
306311-A Rev 00
10.
Using a Phillips screwdriver, tighten 2 captive screws in the extractors
and the 2 captive screws above the extractors (Figure 3-3)
.
Figure 3-3. Tightening the Extractor Screws
11.
Connect the cabling to the new interface.
For cabling information, see Chapter 4, “Connecting Cables.”
12.
Turn power on, and check the diagnostic LEDs on the front panel of the
system processor card.
Module 3
Module 4
Module 5
4
Remote
Console
System
Processor
Expansion Card
Expansion Card
Voice Processor
COM
U
ISDN BRI
withNT1
Telco
V.34 Modem
COM
FBR0092A
PCI Slot 1
PCI Slot 2
PCI Slot 3
PCI Slot 4
Comentarios a estos manuales