
Online help 2 Command interface overview
14 NN47928-107
config - Configure an element's parameters
display - Displays the current configuration of an element
del - Delete a particular element
show - Shows the current active information about an
element
stats - Statistics about a particular element
clear - Clears statistics for an element
Parameter:
Boolean parameters are set by their name, unset by the 'no'
parameter.
IP parameters can be ranged, have masks (/24). For example,
192.16.1.20-192.16.1.25 and 192.168.1.1/24 are both valid IP
parameters.
Certain numeric parameters take a '+' or a '-' preceding the
numeric value as in
the case of 'config voice fxo gain tx -5.'
For parameters which are an enumerated type, you can cycle
through options with
'<TAB>' while in interactive edit mode.
Custom Help:
Type help command mng-element
This provides help on the element. For example, 'help config
interface ip.'
You can also use the '<TAB>' and '?' keys to display
additional help:
'config interface ip <TAB>' or 'config interface ip?'.
Specific help
Perform one of the following actions for specific help.
z Specify the command on the help command
z Enter part of the command followed by the Tab key or the ? key
For example, for information about the command to configure an IP
interface, enter any of the following commands:
> help config interface ip
> config interface ip?
> config interface ip<TAB>
In response to any of the preceding commands, the online help display lists
the parameters for config interface ip, as follows:
> config interface ip
[if] Interface to change behavior of (eth0 | eth1)
ip IP address and mask of interface
mtu The Maximum Transmission Unit (MTU) of the
interface (72-1500)
dhcpclient Obtain address using DHCP (no | yes)
status Configuration status of the interface (up | down)
speed Speed/Duplex (Auto | 10Half | 10Full | 100Half |
100Full)
Comentarios a estos manuales