Avaya Bogen Universal Paging Access Module Manual de usuario descargar pdf (Pagina 16)

Station Port/Centrex Connections (cont'd)

Inhibit Default Timer

Changing Default Timer Range

Ring Delay

An option is available to inhibit the default timer. Do not inhibit the timer if AUX

switches S4 and S5 are in the OFF position (outlined in Important Centrex Settings

on page 15) and the VOX DELAY timer has been disabled (MODE switch S5 is

OFF). This situation may cause the UPAM to remain off-hook indefinitely. Also, do

not inhibit both the default and VOX timers unless the station line has CPC

capability.

To inhibit the default timer, set AUX switch S2 in the ON position. (NOTE: The

VOX and CPC disconnect methods are still available when the default timer is

inhibited.)

To change the timing of the default timer, set AUX switch S 1 to the ON position

(make sure that AUX switch S2 is OFF). This switch position will change the

default time to approximately 25 seconds minimum to 2 minutes 30 seconds

maximum.

Setting AUX switch S3 in the OFF position increases the length of time it takes to

answer the ringing line. This allows time for a talk path to be established before the

UPAM answers, thereby ensuring that the pre-announce or confirmation tone will

be heard. Central office or Centrex lines, which may be slower than other switching

equipment, may require this change.

Table 1. AUX Switch Settings

AUX Switch Bank

Default Timer Enable

6 sec. - 35 sec.

25 sec. - 2.5 min.

Default Timer Disable

Ring Delay Enable

Ring Delay Disable

Page Port, Loop/Gnd. Start Operation

Std. Station Port Operations

Centrex/OSI Operation

OFF

S1. S2

—

S4, S5

—

S4, S5

Figure 5. AUX Switch Bank Location (top edge of unit)

[16]

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Sin comentarios

Avaya Bogen Universal Paging Access Module Manual de usuario Pagina 16