Avaya HSSI Net Module in an ASN Platform Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 38
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Installing the HSSI Net Module in an ASN Platform
1-2
117406-A Rev. A
Removing the ASN Component Tray
You need a Phillips screwdriver to complete this procedure.
To remove the ASN component tray:
1.
Turn off the ASN.
2.
Detach all cables, including the power cable, from the ASN back panel.
3.
Using a Phillips screwdriver, loosen the two captive screws that fasten the
tray to the chassis (Figure 1-1).
a.
Pull out the two captive screws and gently slide the tray out of the
chassis a few inches (F
igure 1-1).
b.
Hold the sides and bottom of the tray to support it as you slide it out;
try to keep the tray level.
4.
Place the tray on a sturdy work surface.
Caution:
Do not touch any ASN components or boards until you have
attached an antistatic wrist strap. See the next section, “Attaching the
Antistatic Wrist Strap.
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Comentarios a estos manuales

Sin comentarios