Avaya Hardware Compression Net Modules in ASN Platforms Manual de usuario descargar pdf (Pagina 23)

115374-A Rev. A

1-1

Chapter 1

Installing a Net Module

To install a Hardware Compression net module in an ASN:

1. Remove the ASN component tray.

2. Attach the antistatic wrist strap.

3. Remove the ﬁller brackets.

4. Remove the net module you want to replace from the ASN (if necessary).

5. Install the new net module.

6. Replace the ﬁller brackets.

7. Replace the component tray.

The following sections describe these steps.

Note:

Use the Hardware Compression net module with the Dual Sync or

Dual Sync/ISDN BRI net module. You can run only one Hardware

Compression and Sync pair in an ASN or ASN stack.

Note:

Experienced network operators can safely perform the user-serviceable

procedures that are described in this book.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Sin comentarios

Avaya Hardware Compression Net Modules in ASN Platforms Manual de usuario Pagina 23