Avaya 3900 Series Key-Based Accessory Module Guía de instalación Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 3
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Standard 2.00 2 of 3 N0023535
Avaya 3900 Series Key-Based Accessory Module Installation Guide
Figure 2: KBA Footstand Assembly
Add a second KBA
1. Place the telephone and the two KBAs face down on a non-abrasive surface.
2. Plug the cable from the second KBA into the 10-pin connection port on the first
KBA.
3. Thread the cable through the routing clips on both Modules, as shown in
Figure 1.
4. Install the Expansion KBA Footstand.
Installing the Single
KBA Footstand
Assembly
1. Insert the clips on both the telephone and the KBA into the hinges on the
Footstand Assembly, and press on the front of the footstand until they snap into
place.
2. While squeezing both the telephone and the KBA tilt handles, swing the
footstand into the desired position.
3. Turn the completed assembly upright.
Installing the
Expansion KBA
Footstand Assembly
1. Place the Single KBA Footstand Assembly and the Expansion KBA Footstand
Assembly face down on a flat surface.
2. Align the Expansion KBA Footstand Assembly with the Single KBA Footstand
Assembly and slide them together.
3. Insert two screws through the Expansion KBA Plate into the Single KBA
Footstand Assembly (see Figure 2).
4. Tighten all four screws, ensuring that the two footstand assemblies are properly
aligned.
5. Insert the clips on the telephone and the Key-Based Accessory Modules into the
hinges on the combined Single/Expansion KBA Footstand Assembly, and while
squeezing the KBA tilt handles, swing the footstand into the desired position.
6. Turn the completed assembly upright.
Expansion KBA
Footstand Assembly
Single KBA
Footstand Assembly
Expansion KBA Plate
Install and tighten
these screws
Tighten
these screws
Vista de pagina 1
1 2 3

Comentarios a estos manuales

Sin comentarios