Avaya FireWall-1 Manual de usuario descargar pdf (Pagina 43)

Configuring a Firewall on a Router

117384-D Rev 00

3-3

Disabling and Reenabling a Firewall on a Router

By default, a firewall is enabled when you first create it on the router.

To disable a firewall, navigate to the firewall prompt (for example,

box

;

firewall

) and enter:

state disabled

For example, the following command disables the firewall on the router:

firewall#

state disabled

firewall#

To reenable a firewall, navigate to the firewall prompt and enter:

state enabled

For example, the following command enables the firewall on the router:

firewall#

state enabled

firewall#

Setting Up Communications Between the Firewall

Management Station and the Router

The firewall cannot protect your router until you set up communications between

the firewall management station and the router. You must also establish the

relationship between each backup firewall management station and the firewall

management station it supports.

To establish these relationships, you must use the same IP address you used to

obtain FireWall-1 licenses for the router and each firewall management station.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Sin comentarios

Avaya FireWall-1 Manual de usuario Pagina 43