
Configuring NetBIOS over IP
8-9
Editing NetBIOS Parameters
The following sections show you how to use Site Manager to configure NetBIOS
over IP.
• Configuring NetBIOS on the Router - page 8-9
• Editing NetBIOS/IP Global Parameters - page 8-10
• Editing NetBIOS/IP Interface Table Parameters - page 8-15
• Editing NetBIOS/IP Static Entry Table Parameters - page 8-18
• Adding a Statically Configured NetBIOS Name - page 8-20
For each NetBIOS parameter, this chapter provides information about default
settings, valid parameter options, the parameter function, instructions for setting
the parameter, and the Management Information Base (MIB) object ID.
The Technician Interface allows you to modify parameters by issuing
set and
commit commands with the MIB object ID. This process is equivalent to
modifying parameters using Site Manager. For more information about using the
Technician Interface to access the MIB, refer to Using Technician Interface
Software.
Configuring NetBIOS on the Router
Before you can configure NetBIOS/IP on the router, you must perform the
following operations to ensure that the slot is properly set up for IP:
1. Open a configuration file.
2. Specify a slot and configure a link module on the slot (if the configuration file
is a local mode file).
3. Select a link or net module connector and configure a circuit on the connector
or configure a WAN circuit if this connector requires one.
For instructions on performing these operations, see Configuring Routers.
Once you have configured a circuit, you are finished with the Add Circuit window.
Caution: The Technician Interface does not verify that the value you enter for
a parameter is valid. Entering an invalid value can corrupt your
configuration.
Comentarios a estos manuales