
304111-B Rev 00
3-1
Chapter 3
Configuring IPsec
This chapter includes the following information:
Enabling IPsec and IKE
To enable IPsec, configure an IP interface using the Configuration Manager. Then
add IPsec services to that interface to create a security gateway. Use the following
steps.
Topic Page
Enabling IPsec and IKE 3-1
Creating Policies 3-2
Creating Security Associations 3-8
Disabling IPsec 3-13
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on the WAN connector on which you
want to configure an IPsec interface.
The Add Circuit window opens.
2. Click on OK. The WAN Protocols window opens.
3. Choose a WAN protocol (PPP or frame
relay).
The Select Protocols window opens.
(continued)
Comentarios a estos manuales