
117372-A Rev. A 3-1
Chapter 3
Enabling VINES Services
This chapter describes how to enable VINES services. It assumes you have read
Configuring and Managing Routers with Site Manager and that you have
1. Opened a configuration file
2. Specified router hardware if this is a local mode configuration file
3. Selected the link or net module connector on which you are enabling VINES,
or configured a WAN circuit if this connector requires one
When you enable VINES services on a circuit, you do not have to configure any
VINES parameters. The Configuration Manager supplies default values for all
VINES parameters. If you want to edit these default values, r
efer to Chapter 4.
Enabling VINES on an Interface
To enable VINES on an interface, complete the following steps:
1. Select VINES from the Select Protocols menu.
The Select Protocols menu appears after you either select a link or net module
connector, or finish configuring a WAN circuit.
2. Click on OK to exit from the Select Protocols menu.
The window in F
igure 3-1 appears.
Comentarios a estos manuales