4
BCM 3.0 Voice Mail Reset
Have you ever tried to login into CallPilot and were
prompted with a dialog box indicating password
incorrect and your demo is about to start in 10
minutes? Here is a step by step procedure to reset the
Voice Mail.
Login to CallPilot Manager and reset the password on
the specific mailbox that you cannot login to (It will
then be 0000).
If you cannot find/remember the CallPilot Manager
password it can be reset (see steps outlined below
from 20 Chapter 2 Using CallPilot Manager from the
user docs "CallPilot Manager Set Up and Operation
Guide" from early BCM 3.5 documentation - this is
valid on BCM 2.5, 3.0 as well.)
To reset the System Administrator password: CallPilot
Manager
If you forget the System Administrator password, you
must reset the password through a telephone on your
system. The password resets to the default password
0000. You must then log on toCallPilot Manager using
the default password 0000 and create a new
password.
To reset the System Administrator password:
Business Communications Manager and CallPilot
100/150
Note: If you reset the System Administrator password,
log on to CallPilot Manager and create a new
password immediately to prevent unauthorized access
to the system. While the default password is used
CallPilot Manager or Call Center is open to
unauthorized access. For additional security, change
the Administration Password regularly.
1) Press ≤·°..
The Voicemail DN appears on your display.
2) Press ·.
3) Enter Resetsmpswd or ‡.‡.°‡.‡‡·. (73738767793)
and press OK or ￡.
4) Press YES.
5) Follow the instructions in "Starting CallPilot
Manager" on page 18 to log on to CallPilot Manager.
6) Use the default password 0000 to log on.
Create a new System Administrator password.
Set <xxxx>
OK
Pswd:
RETRY OK
Pswd:
RETRY OK
Reset pswd?
YES NO
Exit
Connecting the i2002/i2004 IP Phone to the
BayStack 460-24T-PWR
By default, when you attach an i2004 or i2002 IP
Phone to a BayStack 460-24T-PWR that is running
software version 2.3.0.9, power will not be supplied to
the phone. You must make a change in order for
power to be delivered to the phone. Making this
change will affect the entire switch unit and it cannot
be made on a per port basis. However, this setting
can be different between units in a stack. The
command below is a valid command in both version
2.3.0.9 of BayStack 460-24T-PWR code (the code the
switch currently ships with) as well as BoSS 3.0 code.
Please note that this change is not necessary when
using BoSS 3.0 code since this setting is a default.
This command cannot be entered from the system
console menu; it must be entered from the Command
Line Interface. This change can also be made from
the Web Interface as well as Java Device Manager.
To display the current Power over Ethernet settings,
issue the following command in the CLI:
460-24T-PWR>sho poe-main-status
(12 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales