Avaya Ethernet Link Modules in BN Platforms Manual de usuario descargar pdf (Pagina 26)

Installing Ethernet Link Modules in BN Platforms

1-4

114946-A Rev. A

The Backbone Node hot-swap feature allows you to remove or replace a link

module with the chassis power on or off.

When you remove a link module with the power on, the services that slot provides

become disrupted. After the slot fails to receive packets, the other link modules in

the chassis resynchronize their routing tables and continue uninterrupted.

The procedure for removing a link module is the same for the BLN, BLN-2, and

BCN platforms:

Disconnect any exterior cables from the link module.

Attach an antistatic wrist strap.

BN platforms and link modules ship with an antistatic wrist strap. You must

wear one of these straps when accessing components on BN platforms. The

antistatic wrist strap directs the discharge of static electricity from your body

to the chassis, thereby avoiding discharge and possible damage to sensitive

electronic components.

Loosen the captive screw on each end of the module.

4. Grasp the sides of the module and pull it out of the slot.

5. Place the module in an antistatic protective bag.

Danger: Do not remove more than two adjacent modules with the power on.

Caution: Electrostatic discharge can damage hardware. Always use the

antistatic wrist strap when handling any component on your BN platform.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Avaya Ethernet Link Modules in BN Platforms Manual de usuario Pagina 26