Avaya Configuring BFE Services Manual de usuario descargar pdf (Pagina 135)

Connecting the Router to a Blacker Front End

305753-A Rev 00

5-3

Configuring Blacker Front-End Support

To configure BFE support on an IP interface, you must:

• Configure an X.25 interface that conforms to the BFE requirements described

in this section.

• Enable the IP routing protocol on the interface.

• Enable RIPSO support on the interface.

Beginning at the Configuration Manager window, perform the following

procedures:

Configure an X.25 interface.

When you initially configure packet-level parameters for the X.25 interface,

make certain to:

Set the Network Address Type parameter to BFE_NETWORK.

Set the DDN IP Address parameter to the IP address that is assigned

to your BFE connection.

Edit the packet-layer parameters for the X.25 interface to match the

settings specified in Tab le 5 -1

Add network service records to the X.25 interface.

Edit the network service record parameters for the X.25 interface to

match the settings specified in Table 5 -2

Remember to set the DDN BFE parameter to Enable.

Enable the IP routing protocol on the X.25 interface.

The specified IP address must match the one specified in the packet-layer

parameter setting.

Edit the IP interface record.

The address resolution must be set to X.25 BFE DDN. Also, configure IP

security options (RIPSO) on the interface. IP security must be enabled, and

labels are required on all outbound data.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 179 180

Sin comentarios

Avaya Configuring BFE Services Manual de usuario Pagina 135