
BCM INTEROPERABILITY WITH COMMUNICATION SERVER 1000 AND MERIDIAN 1 WITH IP TRUNK
V
ERSION 5.2 JUNE 2007 PAGE 6 OF 20
Table 4: Supported H.323 Functionality - BCM and Communication Server 1000 Release 4.0 and 4.5
Supported
Functionality
(with CS1000 4.0 and
4.5)
Description BCM 3.7
and
BCM50R1
BCM 4.0
and
BCM50R2
Registration:
• Registers as an H.323 Endpoint
Supported Supported
Signaling method:
• Gatekeeper Resolved
Supported Supported
CS1000 4.0/45
Network Routing
Server (NRS)
Alternate Gatekeeper
Supported
(Programmable)
Supported
(Programmable)
Succession 4.0/4.5
IP Peer Gateway
(Signaling Server)
H.225 Call Signaling (using Nortel Interoperability
format)
H.245 Media Channel Signaling
Supported Supported
H.323 Basic Call
Call connection with Calling Line ID
Supported Supported
CDP dial plan
Supported Supported
UDP dial plan
Supported Supported
Private Dial Plan
• BCM private dial plan can only be configured for either CDP or UDP, not both
simultaneously.
Applications:
The following are typical applications that can be
supported using MCDN features:
• Centralized Voicemail,
• Central Attendant (Basic),
• Centralized Trunking
Supported
Supported
MCDN Features:
Private Name/Number
Supported Supported
Trunk Anti-Tromboning (TAT)
* Refer to
Table 6
Supported*
Supported
(See note)
Notes:
• BCM 4.0 and BCM50R2 have enhanced the BCM TAT implementation to enable
TAT support on CTI based calls (eg. calls using BCM AutoAttendant functionality).
Trunk Route Optimization:
• Before Answer (TRO-BA)
• Call Modification (TRO-CM)
* Refer to
Table 6
Supported*
Not Supported*
Supported*
Not Supported*
Network Call Redirection
Supported Supported
Message Waiting Indication (MWI)
Supported Supported
Message Indicator Key (MIK)
Supported Supported
Message Cancel Key (MCK)
Supported Supported
Station Camp-on
Supported Supported
Barge-In
Supported Supported
ISDN Call Connection Limit (ICCL)
Supported Supported
MCDN Networking
Notes:
• On the BCM, these capabilities are enabled via the Nortel Voice Networking
(MCDN) keycode. The BCM Gateway Protocol must be set to “CSE”.
T.38 Fax
Fax detection during H.323 call; renegotiation to T.38
* Refer to
Table 6
Supported* Supported*
Comentarios a estos manuales