Avaya BCC show Commands for IP Services Manual de usuario descargar pdf (Pagina 57)

IGMP show Commands

305755-A Rev 00

5-3

show igmp interfaces

The

show igmp interfaces

command displays information about all configured

IGMP interfaces.

This command allows for the following command filter and argument:

The output includes the following information:

-name

<circuit_name>

Displays IGMP interface information for the specified

circuit only.

Circuit Name of the circuit on which IGMP is configured.

State State of the IGMP interface: up or down.

Query Rate How often (in seconds) the router sends general queries

on the interface.

DR Timeout Designated router timeout value (in seconds). This value

specifies the amount of time from the last host query

message that will be used to determine the loss of the

IGMP designated router.

Membership Timeout Amount of time (in seconds) that a local group

membership is valid without the receipt of a subsequent

report for that group.

Designated Router IP address of the current IGMP designated router. If there

are multiple routers on a multiaccess network, this value

specifies the router sending the IGMP host queries.

Net Version Version of IGMP that the router is running on this

network. A value of 1 means IGMPv1 (the older version of

IGMP); a value of 2 means IGMPv2 (the newer version of

IGMP).

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

Sin comentarios

Avaya BCC show Commands for IP Services Manual de usuario Pagina 57